Questions & Answers for: cleat nailer

...does not contain a jam. 2. check to make sure the driver retracts fully to allow the cleat to advance 3. Be sure to have at least 90psi and to hit the head hard enough to fully fire the

...nailer seems to bounce too much. We are trying to install unfinished pine tongue and groove. Please help! you may have too long of a cleat, also check your psi on the compressor. you should have 90 ...

I have a central pheumatic stapler model 99640. When I used it, it shot out 2 'L' shape cleat (16G, 2") at the same time instead of 1 cleat. I tried to minimize the gap for the mouth, it end up jamed.

what is the correct way to place the nails into the gun? This gun uses both cleats and staples. I am using cleats but it does not seem to be working. I may be putting the cleats in wrong. If you have ...

My MFN-201 cleat driver will not drive the cleats deep enough into the 3/4 inch prefinished bruce flooring. It postitions the cleats fine. It is on the Rachet setting. There is a piece of rubber under

FCN 200 cleat nailer - nailer fires when safet trigger is pulled before the mallet strikes the nailer needs lubed

...cleat is in position, activate nailer to check for proper function. If driver does not return to top of cylinder and was difficult to push up, pull out driver and check for bent /damaged driver and ...

...nailer is stuck with cylinder in the down position. Brand new refurbished, about 50 2" cleats driven without a problem, then some sort of misfire resulting in the stuck cylinder. It drove the ...

...cleat nailer worked great for about 10 nails. Now it doesn't discharge at full pressure. Have checked every thing. Looked for jams ect. help Set your compressor at a higher psi. Maybe you need a ...

cleat nailer does not fire. It just hisses when hit, it doesn't bang. not jammed. Enough pressure , been lubed. The first 10 nails worked great. Some time it is a derbies which was left in assembly by