Questions & Answers for: direct tv message

TV only stays on for about 10 minutes, and then the screen goes black with the message "no sync, no signal" and then after about 15 more seconds it gives the message " power saving"

...Direct TV and I know that the cable connected to the TV is Ok, but still the message comes up. Any suggestions? Ok, cable connected is good. Can you move tv to another connection or run another cable ...

direct tv remotes to operate tv's as well as the direct tv box here is a link with the code sets for this remote: direct TV remote codes here is a link to programing guides: Programing a remote choose

Direct TV and before the new tv, we were using one of their DVR player/recorders. We upgraded to a HD DVR which was installed on 1/9/11. The DVD/VCR player now gives us the following message: Disc may

...message When tv is switched on it displays Power Saving:low message. We also have intermittant problems with losing the signal and wonder if it is linked - the tv is plugged into a surge protector. ...

...TV and devices. Replace with new cables to test them. If you use an OTA antenna with a splitter, try a direct connection. (Similarly, if you have an amplifier on the signal, try a connection without ...

tv We have Direct TV in the house. My TCL remote was lost. Now my screen is blue with error message "no signal". I do not know what button to select on the CHUNGHOP E-T908 universal remote replacement

...tv, I followed all directions. There is a message on the screen that says run channel auto scan. How do I complete set up? Dish remote was set up to work old tv. Is that remote the problem? Should I ...

...TV- using Direct TV. Also cannot reach service line which I pay for monthly.Samsung TV- Direct TV. Picturing working in Living Room, not in Bedroom. Make sure the DirecTv receiver is powered, and the ...

this message is because there is no direct connection between the recorder and the TV! where do you see the message, if on the recorder then check cable connections! if on TV then turn on the recorder