...Akai PDP-5016H 50" Plasma TV's and two of them have failed with the same problem. The screens are just grey. When powered on, the screen goes from black to grey and the fans work, but I cannot get ...
...2 error and the drive reads on my akai dps 12 {record not ready) and unable to format. Either the cable is defective, or the scsi device, or you just need reinstalling scasi driver we need more ...
...the got you for 600. thats well overboard. now you got a blue convergance problem because its erroring out durrent the blue reading in the test. what you need is to take off the screen turn on ...
Question about 51PP9910 51" Rear Projection HDTV
...error codes 61 and 16 where present in the CSM The most likely cause is shorted convergence chips and possibly a few pico fuses. These sets need to have all three colors - RED - BLUE - GREEN - lined ...
Question about 65H81 65" Rear Projection Television
...error Projection TV sets have two very common problems listed below. Problem #1) Convergence These sets need to have all three colors - RED - BLUE - GREEN - lined up correctly on the screen in order ...
Question about WT-42311 42" Rear Projection Television
...error code 2-2 what do I do now. How much would it cost someone else to come and fix 22 is an error code for convergence... These sets need to have all three colors - RED - BLUE - GREEN - lined up ...
Question about PT5598HD 55" Rear Projection HDTV-Ready Television
...2 sustain boards. Board swap jokeying practices dont fix it either as they need to be tuned and syncronised with special tools as well as assuring voltages are correct at each test point. I consider ...
error message. I turned it off and on and it froze during A.Load. I took out the mem card and it loaded the internal seq's/samples fine. I've had this machine for 3 yrs with no problems...Please HELP!
Question about MPC-4000 Plus Production Center (w/80 GB Hard Drive&Onboard Sounds)
...2 inch floppy have secure connections and are not faulty even the electrical extensions or just replace them they are probably old and faulty a computer needs its connections to have an end so any ...
...error red line not straight All projection TV sets have two very common problems. One is convergence ( 3D/Warped video or dead set) the other is CRT fluid ( Dull Video). Here are more details and ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions
