Questions & Answers for: floor nailer

...FLOOR NAILER WHEN I USE IT IT BENTS THE STAPLES. I HAVE MY AIR COMPRESSER set AT 90PSI AND ITS A NEW COMPRESSER. THE NAILERS IS ABOUT TWO YEARS OLD. D Farley, I repair these nailers all the time. ...

floor nailer, 2" nail not going into harwood when using the pne. nailer, the nail goes in half an inch? anyone know why that would be, the compressor is in good condition and so is the nailer. sounds ...

5/8 flooring nailer can the Stanley Bostitch MIIIFN be adjusted to nail down 5/8" prefinished flooring the base plate may be shimmed, but that unit was designed for 1/2" and 3/4" however, the Bostitch

...chamber of a porta-nailer floor gun More likely an O-ring. When they spring a leak, you buy a kit that contains all the gaskets and O-rings and replace them all. An easy job. Hope this

can u use a m3 model to nailer 3/8 flooring yes, you need to shim up the plate of the nailer so the cleat goes thru the "v" of the top of the tounge

...one at amazon.com for about $277. here is the link http://www.amazon.com/Porta-Nailer-403-Hardwood-Flooring-Nailer/dp/B00030MM6C ...

...floor nailer stop getting any air pressure to fire The floor nailer was doing fine and suddenly stopped firing with pressure. Air Compressor is good and so is hose. You broke the seel inside the gun ...

...floor nailer was working fine and has just stopped firing nails. There is no jam, the air compressor is working and the hose is good. what has happened? You broke a seel or dont have it plugged in to ...

floor stapler that is jammed. I do not have a manuel and want to know what steps to take to clear the jam? Model # M III Is it the Flooring Stapler MIII FS or the Flooring Nailer MII IFN? I can try to

How do I remove the drive bar from my M111? Replace drive bar in bostitch m111 flooring nailer - Fixya www.fixya.com/support/t25987854-replace_drive_bar_in_bostitch_m111 37 mins ago - Replace drive ...