Questions & Answers for: Sharp mirror reset

...reset 14, but seems the carriage is stuck. I would like to remove the glass and check what is stuck, but I[m not sure how to do it safely. Please help me asap! Thank you guys. Most likely the scanner ...

...reset procedure code f5 for sharp al2030 Sharp AL-2030 code E7 03 Scanner position error 04 Exposure lamp blown 05 CCD calibration error 12 White level calibration error 14 Main board malfunction 15 ...

...mirror in the laser unit has failed. Try shutting the unit down/unplugging it for 30+ seconds. If this does not reset the fault, you will need to have the laser unit (the LSU) replaced by a trained ...

...mirror assembly, motor, sensor, board. Your copier has a stepping motor failure and a sensor failure. Needs to be serviced. Hope this helps. This is a magnification Lens movement failure. Turn the ...

...mirror motor not up to speed H2 00 Fusing unit temperature error H3 00 Overheated fusing unit H4 00 The fusing unit doesn't heat up U2 01 Counter error 04 EPROM error CH blinking Dev unit is not ...

...that does not resolve the problem, there is a motor in the laser unit that has a motor with small mirrors attached. That is the most likely part failure. xerox wc 5016m/c error code u 70 what does ...

...failed this will also give this code. With the power off and the machine unplugged try cleaning the mirrors and the white strip under the glass. It is sometimes possible to fit the glass upside down ...

...developing unit being careful not to drop the developer, clean the paper feed rollers, exposure mirrors, laser crystal. check heat and pressure rollers and bushings, clean the paper path in the ...

reset it 2. still error occurred, check wire harness of laser unit & clean laser unit mirrors,reflector polygon mirror. 3. still occur just replace toner cartridge because once it works for me. 4.

...reset Use # * C * to access SIM mode. Use SIM 1-1 to check the mirror reciprocating operations. When the mirror does not feed. Check for disconnection of the scanner wire. Check the harness and the ...